The weeks before and after the startup

It’s been a busy winter and we haven’t really updated you enough. Heres a quick recap of the last week and the first burnout video with the new engine 🙂 You will get more posts about the specifics of the engine as Jesse have the time to write em. You can read the first one here.

Cleaning up and getting the electronics of the car was a huge jobb.

Cleaning up and getting the electronics of the car was a huge job.

 

Basically we cut one wire and checked if it still started and then the next one.

Turbo boost gauge

The placing of the most important gauge is a very precise job.

320CDI Turbo

The new turbo in place. It’s a lot smaller than the one we have been using. It’s gonna be really interesting to see how it works.

 

 

This are the first two burnouts with the engine where the car is controlled from the drivers seat. Now we can finally take it to the bench and start to tune it. Still a lot to do before we get som REAL power 😉

ps.

If you want to support us check out our shop.

Leave a Reply

Your email address will not be published. Required fields are marked *